LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 2018 >> Charger Pursuit, 5.7L Eng VIN T, 4WD >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> General Servicing >> Heating & Air Conditioning (Service Information) >> Controls >> Transducer, A/C Pressure >> Removal

Transducer, A/C Pressure: Removal

GC0158231Courtesy of CHRYSLER GROUP, LLC
NOTE:

It is not necessary to discharge the refrigerant system to replace the A/C pressure transducer.

  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
  2. Disconnect the wire harness connector (3) from the A/C pressure transducer (2).
  3. Remove the A/C pressure transducer (2) from the Internal Heat Exchanger (1). Remove and discard the O-ring seal.
scientia non olet · About LEMON Manuals