LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 2018 >> Charger Pursuit, 5.7L Eng VIN T, 4WD >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> General Servicing >> Heating & Air Conditioning (Service Information) >> Plumbing >> Line, A/C Liquid >> Removal >> Liquid Line

Liquid Line

GC0158248Courtesy of CHRYSLER GROUP, LLC
  1. Remove the front belly pan. Refer to BELLY PAN, REMOVAL .
  2. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
  3. Recover the refrigerant from the refrigerant system. Refer to PLUMBING, STANDARD PROCEDURE .
  4. Remove the air cleaner housing. Refer to BODY, AIR CLEANER, REMOVAL .
  5. Raise and support the vehicle.
  6. Remove the nut (1) that secures the A/C liquid line (2) to the A/C condenser.
  7. Disconnect the A/C liquid line from the A/C condenser and remove and discard the dual plane seal.
  8. Install plugs in, or tape over the opened liquid line fitting and condenser outlet port.
    GC0158228Courtesy of CHRYSLER GROUP, LLC
  9. Lower the vehicle.
  10. Remove the nut (2) that secures the A/C liquid line to the Internal Heat Exchanger (1).

    Disconnect the A/C liquid line from the Internal Heat Exchanger and remove and discard the dual plane seal.

  11. Install plugs in, or tape over the opened liquid line fittings.
  12. Remove the A/C liquid line from the engine compartment.
scientia non olet · About LEMON Manuals