LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 2018 >> Charger Pursuit, 5.7L Eng VIN T, 4WD >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> A/C Compressor >> Heating & Air Conditioning (Service Information) >> Distribution >> Housing, HVAC >> Removal >> Housing - Air Inlet

Housing - Air Inlet

WARNING:

Review the warnings and cautions for this system before performing the procedure. Failure to follow these instructions may result in serious injury or death.

WARNING:

Disable the airbag system before attempting any steering wheel, steering column, or instrument panel component diagnosis or service. Disconnect and isolate the negative battery (ground) cable, then wait two minutes for the airbag system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to take the proper precautions could result in accidental airbag deployment and possible serious or fatal injury.

GC0170593Courtesy of CHRYSLER GROUP, LLC
NOTE:

The air inlet housing must be removed from HVAC housing and disassembled for service of the recirculation-air door.

  1. Remove the HVAC housing assembly and place it on a workbench. Refer to HOUSING, HVAC, REMOVAL .
  2. Remove the three screws and the HVAC module (4).
  3. Remove the five screws (7 and 9) and separate the air inlet housing (3) from the HVAC housing (8).
scientia non olet · About LEMON Manuals