LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 2018 >> Charger Pursuit, 5.7L Eng VIN T, 4WD >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> A/C Compressor >> Heating & Air Conditioning (Service Information) >> Distribution >> Motor, Blower >> Removal

Motor, Blower: Removal

WARNING:

Disable the airbag system before attempting any steering wheel, steering column, or instrument panel component diagnosis or service. Disconnect and isolate the negative battery (ground) cable, then wait two minutes for the airbag system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to take the proper precautions could result in accidental airbag deployment and possible serious or fatal injury.

GC0170245Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
  2. Remove the push fasteners, disconnect the wire harness connector and remove the instrument panel closeout (3).
    GC0170581Courtesy of CHRYSLER GROUP, LLC
  3. Disconnect the wire harness connector (1) from the blower motor (2).
  4. Remove the three screws (3) that secure the blower motor to the HVAC housing (4) and remove the blower motor.
scientia non olet · About LEMON Manuals