LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 2018 >> Charger Pursuit, 5.7L Eng VIN T, 4WD >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> A/C Compressor >> Heating & Air Conditioning (Service Information) >> Plumbing >> Drier, A/C Receiver >> Removal

Drier, A/C Receiver: Removal

WARNING:

Review the warnings and cautions for this system before performing the procedure. Failure to follow these instructions may result in serious injury or death.

GC0170612Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
  2. Recover the refrigerant from the refrigerant system. Refer to PLUMBING, STANDARD PROCEDURE .
  3. Remove the front fascia. Refer to FASCIA, FRONT, REMOVAL .
  4. Remove the screw (2) that secures the receiver/drier (1) to the right end of the A/C condenser.
  5. Disconnect the receiver/drier from the A/C condenser and remove and discard the dual-plane seal.
  6. Install plugs in, or tape over the opened receiver/drier fitting and the condenser ports.
scientia non olet · About LEMON Manuals