Sensor, Air Temperature, Inlet: Removal: 6.4L

Courtesy of CHRYSLER GROUP, LLC

The Inlet Air Temperature (IAT) sensor (2) is installed into the rubber air intake hose near the front of the throttle body.

Courtesy of CHRYSLER GROUP, LLC

1. Disconnect and isolate the negative battery cable.
2. Disconnect the IAT sensor (2) wire harness connector (1).
3. Turn the IAT sensor 1/4 turn counterclockwise and remove the IAT sensor from the rubber air intake hose.
4. Inspect the sensor probe (3) for any damage.
5. Clean any dirt or debris from sensor base.