LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 2018 >> Charger Pursuit, 5.7L Eng VIN T, 4WD >> Repair and Diagnosis >> Engine Mechanical >> Accessory Drive Belts >> Cooling System >> Engine >> Tube, Heater Hose, Supply >> Installation >> 6.2L

Tube, Heater Hose, Supply: Installation: 6.2L

GC0144611Courtesy of CHRYSLER GROUP, LLC
  1. Using a new O-ring seal, install left side heater tube (3) into water pump housing and tighten the bolt (1) to the proper torque specifications. Refer to 6.2L TORQUE SPECIFICATIONS .
    GC0170070Courtesy of CHRYSLER GROUP, LLC
  2. Using a new O-ring seal, install the right side heater tube (1) into water pump housing.
  3. Install the right side heater tube retaining bolt and tighten to the proper torque specifications. Refer to 6.2L TORQUE SPECIFICATIONS .
  4. Install the bolt(s) (2) securing heater tube(s) (1) to the back of cylinder head and tighten to the proper torque specifications. Refer to 6.2L TORQUE SPECIFICATIONS .
  5. Install the heater hoses onto the heater tubes.
  6. Install the supercharger. Refer to SUPERCHARGER, INSTALLATION .
  7. Fill the cooling system. Refer to STANDARD PROCEDURE .
  8. Connect the negative battery cable.
  9. Start the engine and check for cooling system leaks.
scientia non olet · About LEMON Manuals