LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 2018 >> Charger Pursuit, 5.7L Eng VIN T, 4WD >> Repair and Diagnosis >> Drivelines & Axles >> Wheel Hubs >> Rear Suspension >> Link, Toe >> Installation >> Right Link

Right Link

GC0170049Courtesy of CHRYSLER GROUP, LLC
  1. Position the toe link to the knuckle and at the crossmember.
  2. Install the cam bolt at the crossmember (3).
  3. Install the toe link to knuckle bolt (2). Do not tighten bolt at this time. 
  4. Attach the wheel speed sensor cable (1) to the toe link.
    GC0170587Courtesy of CHRYSLER GROUP, LLC
  5. Hold the toe adjustment cam stationary (cam facing upward). Install the cam washer and toe link nut (1). Do not tighten nut at this time. 
  6. Raise the jack and position the shock absorber into the pocket in the spring link. Install the shock absorber lower bolt.Do not tighten at this time. 
  7. Install the rear exhaust. Refer to MUFFLER, EXHAUST, INSTALLATION .
  8. Install the tire and wheel assembly. Refer to INSTALLATION .
  9. Remove the support and lower the vehicle.
  10. Position vehicle on alignment rack. Raise vehicle as necessary to access mounting bolts.
    GC0170362Courtesy of CHRYSLER GROUP, LLC
  11. Tighten the shock absorber lower bolt (1) to the proper torque specifications. Refer to TORQUE SPECIFICATIONS .
  12. Tighten the toe link bolt at the knuckle to the proper torque specifications. Refer to TORQUE SPECIFICATIONS .
  13. Perform wheel alignment. Refer to WHEEL ALIGNMENT, STANDARD PROCEDURE .
  14. Tighten the toe link bolt at the crossmember after the rear wheel alignment toe is set. Tighten the toe link nut (do not tighten at the bolt head) to the proper torque specifications. Refer to TORQUE SPECIFICATIONS .
scientia non olet · About LEMON Manuals