Bushings, Tension Strut: Removal

NOTE:

When removing the tension strut do not damage the ball joint threads or compromise the grease boot.

Remove the tension strut. Refer to STRUT, TENSION, REMOVAL .

Courtesy of CHRYSLER GROUP, LLC

NOTE:
For this specific repair ONLY , to correctly measure the bushing installation torque, the threads on tool C-4212F MUST BE clean of all oils and grease and dry
Secure Ball Joint Press (special tool #C-4212F, Press, Ball Joint) (1) in a vise and tighten securely, and install Bushing Receiver (special tool #2043103020, Receiver, Bushing) (2) on the lower side of the clamp.

Courtesy of CHRYSLER GROUP, LLC
The chamfered side (1) of the tension strut must face down when the bushing is being removed.

Courtesy of CHRYSLER GROUP, LLC
Install the tension strut in the clamp with the chamfer side facing down and Bushing Remover (special tool #2043102020, Remover, Bushing) (2) on the top side of the tension strut and tighten down the clamp (1).
Tighten the clamp (1) until the bushing is pushed out into the lower cup adapter (3).
Remove the tension strut and bushing from the clamp.