All Wheel Drive

NOTE:

Left side shown in illustration, right side similar.

Courtesy of CHRYSLER GROUP, LLC

Utilizing slit in isolator, install each stabilizer bar isolator on bar. Make sure slit in isolator is positioned toward rear of vehicle once installed on vehicle.
Install stabilizer bar isolator retainer over each isolator.
NOTE:
When attaching stabilizer link to stabilizer bar, make sure link ball joint stem is pointed inboard toward engine cradle.
Install stabilizer bar ends (3) to each stabilizer link (2). Slide link ball joint stem (1) through mounting hole in bar. Loosely install nuts (4) at this time.

Courtesy of CHRYSLER GROUP, LLC
Raise stabilizer bar to engine cradle, placing bushings (3) into mounted position.
Install the stabilizer bar to crossmember bolts (1). Tighten to the proper torque specifications. Refer to TORQUE SPECIFICATIONS .

Courtesy of CHRYSLER GROUP, LLC
While holding stem from rotating at hex or flat tighten the stabilizer link to stabilizer bar nuts (4) to the proper torque specifications. Refer to TORQUE SPECIFICATIONS .
Install belly pan Refer to BELLY PAN, INSTALLATION .
Remove the support and lower the vehicle.