LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 2018 >> Charger Pursuit, 5.7L Eng VIN T, 4WD >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Base Brakes (Service Information) >> Hydraulic/Mechanical >> Caliper, Disc Brake, Rear >> Removal

Caliper, Disc Brake, Rear: Removal

NOTE:

Before proceeding, Refer to CAUTION  and WARNING .

  1. Using a brake pedal holding tool, depress brake pedal past its first inch of travel and hold it in this position. Holding pedal in this position will isolate master cylinder from hydraulic brake system and will not allow brake fluid to drain out of brake fluid reservoir while brake lines are open.
  2. Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
  3. Remove the tire and wheel assembly. Refer to REMOVAL .
    GC0170103Courtesy of CHRYSLER GROUP, LLC
  4. Remove the brake hose to brake caliper banjo bolt (4). There are two sealing washers (one each side of hose fitting) that will come off when bolt is removed. Discard these washers; install NEW  washers on installation.
  5. While holding guide pins from turning, remove the brake caliper guide pin bolts (5).
  6. Remove brake caliper (3) from brake adapter (1).
scientia non olet · About LEMON Manuals