LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 2018 >> Charger Pursuit, 5.7L Eng VIN T, 4WD >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Base Brakes (Service Information) >> Hydraulic/Mechanical >> Pedal(S), Brake And/Or Accelerator >> Removal

Pedal(S), Brake And/Or Accelerator: Removal

  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
  2. Remove driver side silencer under instrument panel.
  3. Remove steering column opening cover. Refer to COVER, STEERING COLUMN OPENING, REMOVAL .
    GC0162412Courtesy of CHRYSLER GROUP, LLC
  4. Remove stop lamp switch wiring harness connector (3).
  5. Remove booster push rod from pin on brake pedal. To do so:
    1. Position small screwdriver between center tang on power brake booster brake pedal pin retaining clip.
    2. Rotate screwdriver enough to allow retaining clip center tang to pass over end of brake pedal pin, then slide retaining clip off brake pedal pin.
    3. Discard retaining clip (2). It is not to be reused. Install NEW retaining clip when assembling. 
  6. Slide booster push rod off brake pedal pin.
  7. Remove four power brake booster mounting nuts (4).
  8. Remove two nuts fastening pedal bracket to upper dash panel.
  9. Push power brake booster forward into engine compartment as far as possible by hand. Do not force it.
  10. Remove brake pedal assembly.
scientia non olet · About LEMON Manuals