Sensor, Wheel Speed, Rear: Installation
- Insert Wheel Speed Sensor (WSS) head into mounting hole in rear of knuckle.
- Install the WSS head to knuckle bolt (1) and tighten to the proper torque specifications. Refer to TORQUE SPECIFICATIONS .
- Install the WSS cable at rear brake rotor shield.
- Connect the WSS cable to the routing clips (2) along the toe link.
- If installing left sensor, clip the WSS cable to the routing clips (1) along the rear of crossmember.
- Connect the appropriate wheel speed sensor (1).
- Remove the support and lower vehicle.
- Perform Verification Test and clear any faults. Refer to STANDARD PROCEDURE .
