LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 2018 >> Charger Pursuit, 5.7L Eng VIN T, 4WD >> Repair and Diagnosis >> Brakes >> Anti-Lock Brakes >> Antilock Brake System (Abs) (Service Information) >> Electrical >> Sensor, Wheel Speed, Front >> Removal >> Removal

Sensor, Wheel Speed, Front: Removal: Removal

NOTE:

Removal process is the same for both sides of the vehicle.

  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
  2. Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
  3. Remove wheel liner. Refer to SHIELD, SPLASH, FRONT WHEELHOUSE, REMOVAL .
    GC0170518Courtesy of CHRYSLER GROUP, LLC
  4. Remove the WSS harness connector from the body connector (2).
    GC0170405Courtesy of CHRYSLER GROUP, LLC
  5. Remove the WSS from the routing clips (1 and 3).
    GC0170475Courtesy of CHRYSLER GROUP, LLC
  6. Remove the WSS from the brake hose routing bracket (1).
  7. Remove the WSS head to knuckle bolt (2). Pull sensor head out of knuckle.
scientia non olet · About LEMON Manuals