Plate, Carrier: Installation
- If servicing the latch, attach the presenter and the latch to the carrier plate.
- Position the carrier plate to the rear door.
- Engage the three carrier plate torx head retainers (1).
- Install the seven carrier plate bolts (2). Tighten the bolts to the proper torque specifications. Refer to TORQUE SPECIFICATIONS .
- Install the rear door latch mounting screws (1). Tighten the screws to the proper torque specifications. Refer to TORQUE SPECIFICATIONS .
- Install the exterior handle support screw (1).
- Position the harness grommet/bracket (1) to the door.
- Install the screws (2) securing the harness grommet/bracket (1) to the door. Tighten the screws to the proper torque specifications. Refer to TORQUE SPECIFICATIONS .
- Connect the door harness to the vehicle body harness.
- Remove the wedge or tape securing the window glass into place.NOTE:
Front door glass shown in illustration, rear similar.
- Slowly lower the glass into place and align with the white regulator tabs.
- Engage the window regulator tabs (2) into the glass tabs (1).
- Apply a clear adhesive patch covering the front window regulator access hole (1).
- Install the exterior door handle. Refer to HANDLE, EXTERIOR, INSTALLATION .
- Close the latch access panel (2).
- Install the screw (1) under the exterior handle.
- Install the rear door trim (3), Refer to PANEL, REAR DOOR TRIM, INSTALLATION .
- Install the exterior handle. Refer to HANDLE, EXTERIOR, INSTALLATION .
- Connect the battery negative cable.
NOTE:
For vehicles equipped with the optional Automatic Express Up power window feature, calibration of this feature is required whenever power to the door module is disrupted.
A battery reconnect procedure must be performed anytime the battery has been disconnected.