LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 2018 >> Charger Pursuit, 5.7L Eng VIN T, 4WD >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Body - Interior & Exterior >> Doors - Rear >> Plate, Carrier >> Installation

Plate, Carrier: Installation

GC0144586Courtesy of CHRYSLER GROUP, LLC
  1. If servicing the latch, attach the presenter and the latch to the carrier plate.
    GC0170840Courtesy of CHRYSLER GROUP, LLC
  2. Position the carrier plate to the rear door.
  3. Engage the three carrier plate torx head retainers (1).
  4. Install the seven carrier plate bolts (2). Tighten the bolts to the proper torque specifications. Refer to TORQUE SPECIFICATIONS .
    GC0144590Courtesy of CHRYSLER GROUP, LLC
  5. Install the rear door latch mounting screws (1). Tighten the screws to the proper torque specifications. Refer to TORQUE SPECIFICATIONS .
    GC0170659Courtesy of CHRYSLER GROUP, LLC
  6. Install the exterior handle support screw (1).
    GC0144589Courtesy of CHRYSLER GROUP, LLC
  7. Position the harness grommet/bracket (1) to the door.
  8. Install the screws (2) securing the harness grommet/bracket (1) to the door. Tighten the screws to the proper torque specifications. Refer to TORQUE SPECIFICATIONS .
    GC0144587Courtesy of CHRYSLER GROUP, LLC
  9. Connect the door harness to the vehicle body harness.
  10. Remove the wedge or tape securing the window glass into place.
    GC0170786Courtesy of CHRYSLER GROUP, LLC
    NOTE:

    Front door glass shown in illustration, rear similar.

  11. Slowly lower the glass into place and align with the white regulator tabs.
  12. Engage the window regulator tabs (2) into the glass tabs (1).
    GC0170729Courtesy of CHRYSLER GROUP, LLC
  13. Apply a clear adhesive patch covering the front window regulator access hole (1).
  14. Install the exterior door handle. Refer to HANDLE, EXTERIOR, INSTALLATION .
  15. Close the latch access panel (2).
    GC0154694Courtesy of CHRYSLER GROUP, LLC
  16. Install the screw (1) under the exterior handle.
  17. Install the rear door trim (3), Refer to PANEL, REAR DOOR TRIM, INSTALLATION .
  18. Install the exterior handle. Refer to HANDLE, EXTERIOR, INSTALLATION .
  19. Connect the battery negative cable.
NOTE:

For vehicles equipped with the optional Automatic Express Up power window feature, calibration of this feature is required whenever power to the door module is disrupted.

A battery reconnect procedure must be performed anytime the battery has been disconnected.

scientia non olet · About LEMON Manuals