LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 2018 >> Charger Pursuit, 5.7L Eng VIN T, 4WD >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Body - Interior & Exterior >> Interior >> Console, Floor >> Installation

Console, Floor: Installation

GC0170695Courtesy of CHRYSLER GROUP, LLC
  1. Connect the electrical connectors (1) under the floor console.
  2. Align the floor duct at the rear of the floor console. Slide the floor console forward to the instrument panel.
    GC0170776Courtesy of CHRYSLER GROUP, LLC
  3. Open the floor console lid and install the four bolts (1) that secure the floor console to the floor and tighten securely.
  4. Install the mat bin and the coin holder bin.
    GC0170620Courtesy of CHRYSLER GROUP, LLC
  5. Install the two screws (1) and tighten securely.
  6. Position the manual park release (4) and install the two screws (3), if equipped. Tighten the screws securely.
  7. Snap the manual park brake cable (5) into the retainer.
  8. Connect the wire harness connector (2).
    GC0170726Courtesy of CHRYSLER GROUP, LLC
  9. Align the floor console side close out panels (1) to the floor console and use hand pressure to engage the retaining clips.
    GC0170662Courtesy of CHRYSLER GROUP, LLC
  10. Align the storage bin (1) and push in to engage the two retaining clips.
  11. Install the screws (2) and tighten securely.
    GC0170250Courtesy of CHRYSLER GROUP, LLC
  12. Position the shifter bezel (1) and use hand pressure to engage the retaining tabs.
    GC0170308Courtesy of CHRYSLER GROUP, LLC
  13. Install the shifter knob (2) and install the screw (4). Tighten the screw securely.
  14. Connect the wire harness connector (3).
  15. Position the shifter boot (1) and engage the retaining clips.
  16. Connect the negative battery cable.
scientia non olet · About LEMON Manuals