With Sunroof
NOTE:
In the event the headliner is damaged or creased during removal, it will need to be replaced with a new headliner.
Use clean gloves or make sure your hands are clean before removing the headliner.
- Disconnect and isolate the negative battery cable.
- If removing the headliner from the vehicle first remove the windshield. Refer to WINDSHIELD, REMOVAL .
- Remove the screw covers and remove the two screws and remove all grab handles.
- Remove the upper C-pillar trim panels. Refer to PANEL, C-PILLAR TRIM, REMOVAL .
- Remove the B-pillar trim panels. Refer to PANEL, B-PILLAR TRIM, REMOVAL .
- The rear of the headliner (3) can now be lowered to service the center high mount stop lamp.
- Using a trim stick or equivalent, release the push fasteners (1) and retainer clips (2) at the rear of the headliner.
- If lowering the headliner fully or removing the headliner, continue with the procedure.
- Remove the A-pillar trim panels. Refer to PANEL, A-PILLAR TRIM, REMOVAL .
- Unclip the headliner wire harness (2) and disconnect the headliner wire harness connector (1) at the right side A-pillar.
- Remove the overhead console. Refer to CONSOLE, OVERHEAD, REMOVAL .
- Remove the screw and the visor supports.
- Remove the screw (1) behind the overhead console.
- Remove the screw cover (1) and remove the two screws (2) from the visor. Let the visors hang until the front of the headliner can be lowered to disconnect the wire harness connector.
- Carefully pull the headliner (2) downward around the sunroof opening to release the hook and loop fasteners (1).
- Lower the headliner (1) slightly at the front and disconnect the sunroof wire harness connector (2).
- Disconnect the visor wire harness connectors and remove both visors.
- The headliner can now be lowered for curtain airbag service or sunroof removal.
- If removing the headliner, carefully remove the headliner through the windshield opening.
