Cover, Seat Back, Front: Installation
WARNING:
Disable the airbag system before attempting any front seat diagnosis or service. Disconnect and isolate the negative battery (ground) cable and wait two minutes for the airbag system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to follow these instructions may result in accidental airbag deployment and possible serious or fatal injury.
- Before proceeding with the following repair procedure, review all warnings and cautions. Refer to SEATS, FRONT, WARNING .
- Position the seat back cover (3) onto the seat back foam and align the clip strips (4) to the molded clips (2).NOTE:
Note that there is a hole (3) in the foam, next to each molded clip, to aid in clip strip alignment/installation.
- Press the clip strip (2) into each molded clip (1).
- Pull the seat back cover tight and fasten the hook and loop fastener on the seat back foam.
- Position the seat back foam assembly onto the seat back frame.
- Align the seat back ventilation plenum (2) with the seat back blower (1) and snap into place, if equipped.
- Install the headrest sleeves (1) and hand tap to engage the tab (1).
- Install all the J-clip retainers (1).
- Install the two push fasteners (2).
- Install the front seat back. Refer to SEAT BACK, FRONT, INSTALLATION .
- Install the front seat. Refer to SEAT, FRONT, INSTALLATION .
