Glass, Door: Removal
- Remove the trim panel from the inside of the front door. Refer to PANEL, DOOR TRIM, REMOVAL .
- Remove the inner belt weatherstrip from the front door.
- Open the latch access panel (1) located on the carrier plate near the lock rod assembly.
- Carefully remove the closeout plug (1) covering the front window regulator access hole located just behind the electronic mirror module.
- Temporarily install the window switch, reconnect the negative battery cable and lower the window until the white regulator tabs are visible in both access holes (1).NOTE:
Typical glass shown in illustration, Charger is similar.
- Using a small round bladed tool (2) or equivalent, release the door glass (1) from the window regulator glass sliders (3).
- Carefully rotate the door glass within the window opening and remove the glass from the door through the window opening.
