Switch, Seat: Installation
NOTE:
Driver seat shown in the illustration. Passenger seat similar.
- Connect the wire harness connector (3) to the power seat switch (1). Make sure the connector is fully engaged to the switch.
- Position the power seat switch to the side shield (5) and engage the four retaining tabs (2 and 4). Make sure the retaining tabs are fully engaged.
- Position the side shield (2) slightly forward and push down to engage the top retaining clips (1), then push rearward to engage the front retaining clip (5).
- Push at the bottom to engage the retaining clips (4).
- Install the screw (3) at the back of the side shield. Tighten the screw securely.
- Fasten the lower straps for the seat back panel.
- Install the trim cover over the seat belt anchor.
- Connect the negative battery cable.
- Verify proper power seat operation.
