Seat Back Vented Motor
WARNING:
Disable the airbag system before attempting any front seat diagnosis or service. Disconnect and isolate the negative battery (ground) cable and wait two minutes for the airbag system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to follow these instructions may result in accidental airbag deployment and possible serious or fatal injury.
- Before proceeding with the following repair procedure, review all warnings and cautions. Refer to SEATS, FRONT, WARNING
.
- Position the vented seat motor to the bracket. Using a rivet gun, secure the vented seat motor into position.
- Connect the electrical harness connector (1) to the vented seat motor.
- Install the seat back cushion and cover. Refer to SEAT BACK, REAR, INSTALLATION .
