Plate, Carrier, Police: Installation
- Position the carrier plate (4) near the rear door.
- Position the manual lock knob assembly (1) in place and secure with the retaining clips.
- Align and position the carrier plate (4) to the rear door.
- Engage the four carrier plate torx head retainers (2).
- Install the seven carrier plate bolts (3). Tighten the bolts to 6 N-m (53 in. lbs.).
- Install the retaining nut (1) securing the manual lock knob to the door. Tighten the nut securely.
- Install the rear door latch mounting screws (1). Tighten the screws to 7 N-m (62 in. lbs.).
- Position the harness grommet/bracket (1) to the door.
- Install the screws (2) securing the harness grommet/bracket (1) to the door. Tighten the screws securely.
- Connect the door harness to the vehicle body harness.
- Remove the wedge or tape securing the window glass (1) into place.
- With the help of an assistant holding the glass (1), lower the glass and align with the regulator tab.
- Engage the window regulator tabs into the glass.
- Apply tape to cover the front window regulator access hole (2).
- Install the exterior door handle. Refer to HANDLE, EXTERIOR, INSTALLATION .
- Close the latch access panel (3).
- Install the rear door trim (1). Refer to PANEL, REAR DOOR TRIM, POLICE, INSTALLATION .NOTE:
A battery reconnect procedure must be performed anytime the battery has been disconnected.
- Connect the battery negative cable.
