LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 2018 >> Charger Pursuit, 5.7L Eng VIN T, 4WD >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Body - Interior & Exterior >> Doors - Rear, Police >> Panel, Rear Door Trim, Police >> Installation

Panel, Rear Door Trim, Police: Installation

GC0144585Courtesy of CHRYSLER GROUP, LLC
  1. Prior to installation, check to be certain that all snap retainers are in good condition on the door trim panel and the door's carrier plate. Replace if necessary.
  2. Position the door trim panel near the door. Do not install at this time. 
  3. Connect the map light harness (1).
    GC0145239Courtesy of CHRYSLER GROUP, LLC
  4. Using firm pressure, engage the door trim snap retainers (1, 2) into the door's carrier plate.
    GC0144674Courtesy of CHRYSLER GROUP, LLC
  5. Install the screw (1) just behind the armrest. Tighten the screw to 2 N.m (16 in. lbs.).
  6. Connect and install the power window switch. Refer to SWITCH, POWER WINDOW, INSTALLATION .
    GC0144675Courtesy of CHRYSLER GROUP, LLC
  7. Install the trim plate (1) just behind the armrest.
    NOTE:

    For vehicles equipped with the optional Automatic Express Up power window feature, calibration of this feature is required whenever power to the door module is disrupted.

    A battery reconnect procedure must be performed anytime the battery has been disconnected.

  8. Connect the battery negative cable.
scientia non olet · About LEMON Manuals