LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 2018 >> Charger Pursuit, 5.7L Eng VIN T, 4WD >> Repair and Diagnosis >> Accessories & Equipment >> Exterior Lights >> Lamps/Lighting - Exterior (Service Information) >> Lamp, Fog >> Installation >> Lamp

Lamp, Fog: Installation: Lamp

  1. Position the front fog lamp mounting bracket to the fog lamp seat on the back of the lower front fascia.
  2. Install and tighten the three screws that secure the mounting bracket to the fascia. Tighten the screws securely.
  3. Install the push pin for routing the wiring harness to the fog lamp assembly.
  4. Connect the wire harness connector to the fog lamp bulb connector receptacle.
    GC0170673Courtesy of CHRYSLER GROUP, LLC
  5. Position the ventilation plenum to the front fascia and secure using two screws (1).
    GC0170749Courtesy of CHRYSLER GROUP, LLC
  6. Install three screws (1) through the wheel liner to secure the ventilation plenum to the vehicle.
  7. Install the front belly pan to the underbody. Refer to BELLY PAN, INSTALLATION .
  8. Connect the battery negative cable.
  9. Confirm proper fog lamp alignment. Refer to STANDARD PROCEDURE .
scientia non olet · About LEMON Manuals