Lamp, Tail Stop Turn: Installation: Lamp: Center

Courtesy of CHRYSLER GROUP, LLC

1. From outside of the vehicle, check to be certain the two grommets (4) are properly installed and in good condition in the deck lid (5) inner panel.
2. Position the center tail lamp unit (1) into the deck lid opening using the alignment pin (2) and two ball studs (3) as guides.
3. Using hand pressure, press firmly and evenly on the two outboard ends of the center tail lamp to snap the two ball studs into the two grommets in the deck lid inner panel.

   Courtesy of CHRYSLER GROUP, LLC

4. From the inside the trunk, install and tighten the eight nuts (2) that secure the center tail lamp (1) to the inside of the deck lid (3) inner panel. Tighten the nuts securely.
5. Reconnect the body wire harness connector (4) to the center tail lamp connector receptacle.
6. Reinstall the trim cover onto the inside of the deck lid.
7. Reconnect the battery negative cable.