When Monitored And Set Conditions
This diagnostic runs continuously when the following conditions are met:
- All ignition positions.
- During the Passive Entry or Keyless Go event.
- Battery voltage is between 10.0 - 16.0 volts.
- Smart sensor is present on the Door Handle.
Set Conditions:
- Whenever the Radio Frequency Hub (RF Hub) detects an open, a short to ground or a short to battery on the Passive Handle Switch Sense circuit for approximately (2) minutes, this code will set.
Default Actions:
- Must use RKE or bladed key to enter the vehicle.
| Possible Causes |
|---|
| FRONT RIGHT PASSIVE HANDLE SWITCH SENSE CIRCUIT SHORTED TO VOLTAGE |
| FRONT RIGHT PASSIVE HANDLE SWITCH SENSE CIRCUIT SHORTED TO GROUND |
| FRONT RIGHT PASSIVE HANDLE SWITCH RETURN CIRCUIT OPEN |
| FRONT RIGHT PASSIVE HANDLE SWITCH SENSE CIRCUIT OPEN |
| FRONT RIGHT PASSIVE HANDLE SWITCH SENSE CIRCUIT SHORTED TO THE FRONT RIGHT PASSIVE HANDLE SWITCH RETURN CIRCUIT |
| FRONT RIGHT EXTERIOR DOOR HANDLE (PASSIVE ENTRY) |
| RADIO FREQUENCY HUB (RF HUB) |