LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 2018 >> Charger Pursuit, 5.7L Eng VIN T, 4WD >> Repair and Diagnosis >> Accessories & Equipment >> Entertainment Systems >> (Audio (Radio) - Electrical Diagnostics) >> DTC Troubleshooting >> B143A-12-Microphone 1 - Circuit Short To Battery >> Diagnostic Test

Diagnostic Test

  1. CHECK FOR AN ACTIVE DTC 
    NOTE:

    Verify the connection of the Inside Rearview Mirror harness connector.

    1. With the scan tool, read Radio DTCs and record on the repair order.
    2. With the scan tool, erase DTCs.
    3. With the scan tool, read Radio DTCs.

      Did the DTC return?

      Yes 

      • Go To  2

      No 

      • The condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals, and correct pin tension. If no problems are found, test complete.
      • Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
  2. CHECK THE INSIDE REARVIEW MIRROR 
    1. Turn the ignition off.
    2. Disconnect the Inside Rearview Mirror harness connector.
    3. Turn the ignition on.
    4. Wait 10 seconds.
    5. With the scan tool, read the active DTCs.

      Is the DTC active?

      Yes 

      • Go To  3

      No 

      • Replace the Inside Rearview Mirror in accordance with the Service Information.
      • Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
  3. CHECK THE (X712) MICROPHONE 1 IN (+) CIRCUIT FOR A SHORT TO VOLTAGE 
    1. Turn the ignition off.
    2. Disconnect the Radio harness C1 connector.
    3. Turn the ignition on.
    4. Measure the voltage between ground and the (X712) Microphone 1 IN (+) circuit at the Radio C1 harness connector.

      Is there any voltage present?

      Yes 

      • Repair the short to voltage in the (X712) Microphone 1 IN (+) circuit.
      • Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .

      No 

      • Go To  4
  4. CHECK THE (X792) MICROPHONE 1 IN (-) CIRCUIT FOR A SHORT TO VOLTAGE 
    1. Measure the voltage between ground and the (X792) Microphone 1 IN (-) circuit at the Radio C1 harness connector.

      Is there any voltage present?

      Yes 

      • Repair the short to voltage in the (X792) Microphone 1 IN (-) circuit.
      • Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .

      No 

      • Replace the Radio in accordance with the Service Information.
      • Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
scientia non olet · About LEMON Manuals