LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 2018 >> Charger Pursuit, 5.7L Eng VIN T, 4WD >> Repair and Diagnosis >> Brakes >> Parking Brake System >> Base Brakes (Service Information) >> Hydraulic/Mechanical >> Booster, Power Brake >> Removal

Booster, Power Brake: Removal

  1. Move driver seat to full rearward position.
  2. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
  3. Remove windshield wiper module. Refer to LINKAGE, WIPER ARM, REMOVAL .
  4. Remove the master cylinder. Refer to MASTER CYLINDER, BRAKE, REMOVAL .
    GC0173372Courtesy of CHRYSLER GROUP, LLC
  5. Disconnect vacuum hose (3) from brake booster vacuum switch (2) on face of booster.
  6. Disconnect the electrical harness connector (3) from the brake booster vacuum switch. Do not remove check valve from booster. 
    GC0170128Courtesy of CHRYSLER GROUP, LLC
  7. Remove stop lamp sensor. Refer to SENSOR, STOP LAMP, REMOVAL .
    NOTE:

    Do not discard the stop lamp switch as it can be adjusted and reinstalled. 

  8. Disengage brake booster push rod to brake pedal retaining clip (3).
    NOTE:

    Discard retaining clip. It is not to be reused. Install NEW retaining clip when assembling. 

  9. Slide booster push rod off brake pedal pin.
  10. Remove the four brake booster nuts (5).
  11. Slide power brake booster forward out of dash panel and remove through opening between cross-brace and windshield.
scientia non olet · About LEMON Manuals