LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 2018 >> Charger Pursuit, 5.7L Eng VIN T, 4WD >> Repair and Diagnosis >> Drivelines & Axles >> Driveshaft & Universal Joints >> Propeller Shaft >> Installation >> Front Drive Shaft

Front Drive Shaft

GC0094956Courtesy of CHRYSLER GROUP, LLC
  1. Install propeller shaft (1) into position.
    NOTE:

    Drive shaft bolts must be replaced with NEW or cleaned and Mopar® Lock and Seal Adhesive or equivalent applied. 

  2. Starting at the transfer case end, align the index marks made during removal and install the drive shaft to transfer case flange bolts (2) hand tight.
  3. Align the index marks at the front axle end of the drive shaft, and install the drive shaft to front axle flange bolts (2) hand tight.
  4. Torque the drive shaft to transfer case and drive shaft to axle flange bolts (2) to the proper torque specifications. Refer to TORQUE SPECIFICATIONS .
    GC0152195Courtesy of CHRYSLER GROUP, LLC
  5. Install the crossmember, the crossmember bolts (1) and the transmission mount bolts (2) and tighten to the proper torque specifications. Refer to TORQUE SPECIFICATIONS .
    GC0152202Courtesy of CHRYSLER GROUP, LLC
  6. Remove the transmission jack (1).
  7. Remove the support and lower the vehicle.
scientia non olet · About LEMON Manuals