LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 2018 >> Charger Pursuit, 5.7L Eng VIN T, 4WD >> Repair and Diagnosis >> Steering >> Steering Linkage >> Steering System >> Pump >> Cooler, Power Steering >> Installation >> SRT

Cooler, Power Steering: Installation: SRT

GC0152318Courtesy of CHRYSLER GROUP, LLC
  1. Install center tube of cooler over mounting clips attached to cooling module. Push cooler past clip retaining tabs allowing it to lock into place.
    GC0170514Courtesy of CHRYSLER GROUP, LLC
  2. Install the hose on (3) on the cooler (2) and securely tighten the clamp (4).
  3. Install the hose clamp (5) on the cooler (2) and securely tighten the clamp.
  4. Install the front fascia. Refer to FASCIA, FRONT, INSTALLATION .
  5. Remove support and lower the vehicle.
  6. Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.
  7. Fill and bleed power steering system. Refer to STANDARD PROCEDURE .
scientia non olet · About LEMON Manuals