Horn System (Service Information): Horn: Installation

Courtesy of CHRYSLER GROUP, LLC

1. Position the horn (3) and mounting bracket as a unit to the Front End Module (FEM) carrier.
2. Install and tighten the screw (1) that secures the horn mounting bracket to the upper radiator cross member. Tighten the screw to the proper specifications. Refer to TORQUE SPECIFICATIONS .
3. Connect the headlamp and dash wire harness connectors (2) to the terminals on the horn.
4. Install the front fascia assembly onto the vehicle. Refer to FASCIA, FRONT, INSTALLATION .
5. Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.