Cooler, Power Steering: Installation: SRT
- Install center tube of cooler over mounting clips attached to cooling module. Push cooler past clip retaining tabs allowing it to lock into place.
- Install the hose on (3) on the cooler (2) and securely tighten the clamp (4).
- Install the hose clamp (5) on the cooler (2) and securely tighten the clamp.
- Install the front fascia. Refer to FASCIA, FRONT, INSTALLATION .
- Remove support and lower the vehicle.
- Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.
- Fill and bleed power steering system. Refer to STANDARD PROCEDURE .
