Hydraulic Power Steering
- Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
- Siphon power steering fluid from pump reservoir.
- Remove air filter housing. For 3.6L, refer to BODY, AIR CLEANER, REMOVAL . For 5.7L, refer to BODY, AIR CLEANER, REMOVAL . For 6.2L, refer to BODY, AIR CLEANER, REMOVAL . For 6.4L, refer to BODY, AIR CLEANER, REMOVAL .
- Remove serpentine drive belt. Refer to BELT, SERPENTINE, REMOVAL
.
- Loosen the hose clamp, then remove the supply hose (1) from power steering pump (3).
- Remove the pressure hose (2) from power steering pump (3).
- Remove the three power steering pump bolts (2) through the access holes in pulley (3).
- Remove the power steering pump (1) from engine.
- If necessary, remove the power steering pump pulley. Refer to PULLEY, POWER STEERING PUMP, REMOVAL .
