LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 2018 >> Charger Pursuit, 5.7L Eng VIN T, 4WD >> Repair and Diagnosis >> Steering >> Power Steering >> Steering System >> Pump >> Hose, Power Steering, Pressure >> Removal >> Hydraulic Power Steering

Hydraulic Power Steering

  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
  2. Siphon power steering fluid from pump reservoir.
  3. Remove air cleaner and inlet tube. For 3.6L, refer to BODY, AIR CLEANER, REMOVAL . For 5.7L, refer to BODY, AIR CLEANER, REMOVAL . For 6.2L, refer to BODY, AIR CLEANER, REMOVAL . For 6.4L, refer to BODY, AIR CLEANER, REMOVAL .
    GC0170527Courtesy of CHRYSLER GROUP, LLC
  4. Remove power steering pressure hose (2) from the power steering pump (3).
  5. Raise and support vehicle. Refer to HOISTING, STANDARD PROCEDURE .
  6. Remove belly pan. Refer to BELLY PAN, REMOVAL .
    GC0170164Courtesy of CHRYSLER GROUP, LLC
  7. Remove the fastener (4) securing power steering pressure hose (3) to the front of engine cradle (1).
  8. Remove screw (2) fastening routing clamps securing pressure (3) and return (5) hoses to right side of engine cradle (1).
    GC0170198Courtesy of CHRYSLER GROUP, LLC
  9. Remove the power steering pressure hose (2) from the steering gear (1).
  10. Remove power steering pressure hose from vehicle.
scientia non olet · About LEMON Manuals